If, for example, you wanted to see all HTTP traffic related to a site at xxjsj you could use the following filter: tcp.port = 80 and ip.addr = 65.208.228.223

If you want to filter for all HTTP traffic exchanged with a specific you can use the “and” operator. Filtering HTTP Traffic to and from Specific IP Address in Wireshark Now you’ll see all the packets related to your browsing of any HTTP sites you browsed while capturing. To display all the HTTP traffic you need to use the following protocol and port display filter: tcp.dstport = 80 You’re missing the setup handshakes and termination tcp packets. The unfortunate thing is that this filter isn’t showing the whole picture. You’ll notice that all the packets in the list show HTTP for the protocol. To display packets using the HTTP protocol you can enter the following filter in the Display Filter Toolbar: http is a good one because they have a very large site that loads a lot of information and (at the time of writing this) they have not switched to HTTPS, sadly. To start this analysis start your Wireshark capture and browse some HTTP sites (not HTTPS). Many people think the http filter is enough, but you end up missing the handshake and termination packets. This would result in displaying all GET's and OK's and see if there is a time delta bigger then 1 sec between them Your time display format should be 'seconds since previous displayed packet' and you would still have to manually connect the dots.Filtering HTTP traffic in Wireshark is a fairly trivial task but it does require the use of a few different filters to get the whole picture. You could combine both filters to this: http and ( = 'GET' || = 200) and see GET's en OK's, you could then right-click a GET > set Time Reference and see how much time it took to the concerning OK, but that seems tedious.įrame.time_delta_displayed > 1 and ( = 'GET' || = 200)

Now to how to combine and see the time difference?.

secondly there should be a moment when the file is on the client, the clients browser might answer : ( = 200).first you would need a beginning: maybe starts with a HTTP request, you could use ( = 'GET') your starting HTTP requests could be different.You could start of with writing down what would be needed to 'see' these times:

Wireshark http response